Troubleshooting - Oricom MX300 Instruction Manual

TROUBLESHOOTING

PROBLEM
The transceiver
does not turn
ON.
No sound from
speaker.
Transmitting
is impos-sible,
or high power
can not be
selected.
The displayed
channel cannot
be changed.
Scan does not
start.
No beep
sounds.
POSSIBLE CAUSE
• The battery is
exhausted.
• The battery pack
is not correctly
inserted.
• The squelch level is
too high.
• Volume level is too
low.
• Speaker has been
exposed to water.
• Some channels are
limited to low power
or only receive.
• The output power is
set to low.
• The battery is
exhausted.
• The Lock function
is activated.
• "TAG" channels are
not programmed.
• Beep Tone function
is turned OFF.
SOLUTION
• Recharge the battery
pack.
• Correctly insert the
battery pack.
• Set the squelch level
to the threshold level.
• Adjust the audio level
to a suitable level.
• Remove water from
the speaker grill.
• Change the channel.
• Push [Hi/Lo] to select
high power.
• Recharge the battery
pack.
• Hold down [
(Hi/Lo) for 1 second
to turn OFF the
function.
• Set desired channels
as "TAG" channels.
• Turn ON the Beep
Tone in the set mode.
REF.
• 1
• 2
• 5, 6
• 1
• 5
• 6
• 7
]
• 9
• 6
• 6
• 11
15