Packing List - Vaniman SandStorm Prestige Original Instructions Manual

PACKING LIST

1 - Micro-Abrasive Blaster
1 - Instructions
1 - DC Power Supply (if applicable)
1 - Additional Air Supply Connection
INSTALLATION & OPERATION
1. Remove the unit and all packaging material from the box. Check against the packing list.
2. For units with lights: Plug the DC Power Supply into the jack on the unit's light and plug the
other end into a standard outlet.
3. Unscrew lid(s) on abrasive storage tank(s) and fill to the line marked on the tank. Do not
overfill as clogging may result.
4. Inspect lid and tank for any cracks or areas that might create leaks. Ensure the threads on
the tank and lid are clean of abrasive before screwing the lid securely back into place. Do not
over-tighten.
5. Use the plumbing diagrams at the end of these instructions to locate the fitting on the back of
the unit to connect your air supply line. Most units come equipped with a barbed fitting for a
1/4" (6mm) ID (inside diameter) hose while the IO/Master units come equipped with a quick
disconnect fitting for a 1/4" (6mm) OD (outside diameter) air line. All Vaniman units are shipped
with both fittings included to meet the customer's needs. For more help on connecting your
unit to an air supply visit:
6. Regulate air pressure by turning the air regulator knob, pulling up on the knob to unlock and
pressing back down to lock. The pressure reading will be indicated on the pressure gauge
and should NOT be adjusted above 100 psi (7 BARS).
7. Never depressurize the system by disconnecting the air supply line while under pressure;
abrasive will be forced into the foot valve and regulator, causing damage. Before disconnecting
the air supply line, turn the regulator down (counterclockwise) until the pressure gauge reads
zero.
25799 Jefferson Ave. Murrieta, CA 92562

www.vaniman.com/air-supply-connections-blasters/
1-800-VANIMAN (826-4626) USA

SANDSTORM PRESTIGE
www.vaniman.com

SANDSTORM PRESTIGE- 05/21 Page 5
ENGLISH
sales@vaniman.
