Home Skinovations Silk'n Jewel Manual page 13

To change the energy level, press the control button (#3 in the diagram)
repeatedly to increase the energy level from 1 to 5. Once at level 5, press the
control button again to reduce the energy level from 5 back to 1.
I
To determine the right energy level for your treatment area, refer
to section "9.1 Before your treatment".
8.3 Pulsing and Gliding
Pulsing is the best technique for working at higher energy levels.
Press the treatment surface against your skin. Work in rows (either across or
down as shown in the image). Start at one end of each row and progress to
the other end. The treatment surface creates temporary pressure marks on the
treated area so you can see areas you have treated. Keep doing this pulsing
action for the area you are treating. Avoid gaps or overlaps between areas.
Do not treat the same area of skin more than once per hair removal
J
J
session.
Gliding is the best technique for working at lower energy levels.
Press the device firmly against your skin and slowly glide over your skin (either
across or down as shown in the image). Make sure that the skin is always
touching the device. At lower energy levels, the device takes only 1-1.5
seconds to recharge between pulses. This generates a nonstop sequence of
flashes. Glide at a speed so that you avoid gaps or overlaps.
Stop use immediately if your skin blisters or burns.
J
J
13
EN