Matco Tools RL200 Operating Instructions Manual page 6

Troubleshooting for the Head
of the Rivet Gun
1. Make sure that there is no air flow going to
the Rivet Gun.
2. Use the spanner to remove the head from the
frame. (Fig. 1)
3. Use the spanner to remove the Jaw Housing,
Jaws, Jaw Pusher, and the Pusher Spring.
(Fig. 2)
4. Thoroughly clean the inside of the Frame
Head. (Fig. 3)
5. Use a light gauge machine oil to lubricate
the
parts shown in figure 4.
6. Re-assemble the Rivet Gun and check the
length of the Rivet Gun Head by using the
spanner as shown in figure 5.
RL200
RL200manual.indd 6
6
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Rev. 04/22/02
10/4/04 4:22:29 PM