Matco Tools MNTS8 Manual

WARNING
Study, understand and follow all instructions provided
with this product. Read these instructions carefully
before installing, operating, servicing or repairing this
tool. Keep these instructions in a safe, accessible place.
INTENDED USE OF THE TOOL
The MNTS8 is designed to set the rivet nuts of the
following thread pitches: 1/4-20, 10-24, 8-32, 10-32,
M4x0.7, M5x0.8 and M6x1.0. Do not use this tool outside
of the designed intent. Never modify the tool for any
other purpose or use.
WARNING
Caution: To help prevent personal injury
• Use of this product can expose you to chemicals
including ethylene glycol, gasoline vapors and engine
exhaust, which are known to the State of California to
cause cancer, birth defects, or reproductive harm. For
more information, visit www.P65Warnings.ca.gov.
Always wear ANSI approved safety equipment, safety
glasses and clothing when using this product. Study,
understand, and follow all instructions provided with
this product. Failure to read and follow all warnings
and operating instructions may result in damages and
serious injury or death.
• Always wear ANSI approved goggles when using this
product. (Users and bystanders).
• Never use this tool for any application other than for
which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool,
modification of the tool, or use of the tool with
accessories not designed for it could result in serious
injury or death.
• Always select the correct accessories of the correct
size and design for the job that you are attempting to
perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
• Do not begin repairs without assurance that vehicle is
in a secure position, and will not move during repair.
BEFORE USE
When unpacking, check the parts diagram and part
number listing on page
included. If any parts are missing or damaged, please
call your distributor.
HAND PISTOL RIVET NUT KIT
7 to make sure all parts are
1 YEAR LIMITED WARRANTY
The manufacturer warrants this product to the original
user against defective material or workmanship for a
period of 1 year from the date of purchase.
The manufacturer reserves the right to determine
whether the part or parts failed because of defective
material, workmanship or other causes. Failures caused
by accident, alteration, or misuse are not covered by
this warranty.
The manufacturer, at its discretion, will repair or replace
product covered under this warranty, free of charge.
Repairs or replacements of products covered under this
warranty are warranted for the remainder of the original
warranty period.
The manufacturer or its authorized service representatives
must perform all warranty repairs. Any repair to the
product by unauthorized service representatives voids
this warranty. The rights under this warranty are limited
to the original user and may not be transferred to
subsequent owners.
The warranty is in lieu of all other warranties, expressed
or implied, including warranties of merchantability and
fitness for a particular purpose. Some states do not allow
the exclusion or limitations of incidental or consequential
damages, so the above limitations may not apply to you.
PRODUCT INFORMATION:
Compact design. Less than 8" long and 4.5" wide for
one-handed use in confined areas.
Power. Sets rivet nut sizes up to 1/4" easier than any other
pistol style tool.
SAE and metric. Includes a rivet nut assortment and
mandrel sizes in 8-32, 10-24, 1/4-20, M4, M5 and M6.
TECHNICAL DESCRIPTION:
Weight: 1.54 lbs. (700g)
Length: 7.48" (190mm)
Max working stroke: 7mm
Max effective working stroke: 5mm
DO NOT DISCARD – GIVE TO USER
Page 1
MNTS8
Made in China
to Matco specifications
2003041-14