Advertisement
Bxxx Issue 3
Electric/Hydraulic Stern Thruster
Owner's Installation, Operation & Basic Servicing Manual
Electric Stern Thruster
Owners Installation, Operation & Basic Servicing Manual
Electric Stern Thruster
Owners Installation, Operation & Basic Servicing Manual
Electric Stern Thruster
Owners Installation, Operation & Basic Servicing Manual
Electric Stern Thruster
Owners Installation, Operation & Basic Servicing Manual
Electric Stern Thruster
Owners Installation, Operation & Basic Servicing Manual
��������������
GB
D
F
E
I
S
Advertisement
Table of Contents
Related Manuals for Lewmar 140TT
Summary of Contents for Lewmar 140TT
- Page 1 Bxxx Issue 3 Electric/Hydraulic Stern Thruster Owner’s Installation, Operation & Basic Servicing Manual Electric Stern Thruster Owners Installation, Operation & Basic Servicing Manual Electric Stern Thruster Owners Installation, Operation & Basic Servicing Manual Electric Stern Thruster Owners Installation, Operation & Basic Servicing Manual Electric Stern Thruster Owners Installation, Operation &...
-
Page 2: Table Of Contents
Electrical 1. Installation 1.1 Choosing location 1.2 Internal structure 1.3 Preparing for fitting 1.4 140TT & 185TT installing hub unit 1.5 250TT & 300TT installing hub unit 1.6 Preparing for final assembly 2. Electrical wiring installation 12/13 2.1 Typical electrical layout 12/13 3. -
Page 3: Introduction
Only persons this manual. Failure to do so could result in poor With a Lewmar winch you will be provided with many who are completely familiar with the controls and product performance, personal injury and/or years of outstanding service. -
Page 4: Installation
1. Installation 1.2 Internal structure Fig 1.21 • The thruster must be in a watertight enclosure that is a minimum of 150 mm (6”) above the Fig. 1.11 waterline. This space must also have adequate ventilation. Access should be from above and the entrance should not allow water in. -
Page 5: 140Tt & 185Tt Installing Hub Unit
Align template horizontally on transom. Offer up stern tube and level, mark holes for • Tighten prop nut to 10Nm (7.4lbs.ft) 140TT drilling. - 15Nm (11lbs.ft) 185TT , a length of wood placed between prop blade and tunnel will stop •... - Page 6 1.5 250T T & 300TT 1.6 Preparing for Fig. 1.53 Fig 1.63 Installing hub unit final assembly The electric motor must be supported as it is being installed horizontally. • Place gasket on hub and locate through centre • Before final assembly of stern tube, check hole.
- Page 7 2. Electrical wiring installation Fig. 2.11 (POSITIVE) STUD* * Solenoid appearance may differ. Electric/Hydraulic Stern Thruster Electric/Hydraulic Stern Thruster Models 185TT, 250TT & 300TT Models 185TT, 250TT & 300TT...
- Page 8 3. Operating your thruster Fig. 3.11 NOTE: Refer to the main thruster manual for control options. Your thruster should not be operated close to swimmers, as a powerful suction of water is • Please ensure that you thoroughly understand generated when in use. the operation and safety requirements of the thruster.
- Page 9 Notice of a claim for service under this warranty shall be made corrosion, ultra violet degradation or wear and tear; promptly and in writing by the end user to the Lewmar outlet which a failure to service or maintain the product in accordance with supplied the product or to Lewmar at Southmoor Lane, Havant, Lewmar’s recommendations;...