Sealey SA22503 Instructions

Direct drive compressor

Download this manual

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.

USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE

DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY INSTRUCTIONS

ELECTRICAL SAFETY

WARNING!

1.2.

GENERAL SAFETY INSTRUCTIONS

p WARNING! Compressor must only be serviced by an authorised agent. DO NOT tamper with, or attempt to adjust, pressure switch or safety valve.

DO NOT

DIRECT DRIVE COMPRESSOR

S A 2 2 5 0 3

Blue

Neutral

Wire

Yellow & Green

Earth Wire

Brown

Live

Wire

Cable

Restraint

FUSE RATING 13 AMP

Page 1 DIRECT DRIVE COMPRESSOR S A 2 2 5 0 3 IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
Page 2 DANGER! DO NOT direct the output jet of air towards people or animals. DO NOT DO NOT p WARNING! The air tank is a pressure vessel and the following safety measures apply: DO NOT tamper with the safety valve and DO NOT modify or alter the tank in any way and DO NOT strap anything to the tank. DO NOT subject the tank to impact, vibration or to heat and DO NOT allow contact with abrasives or corrosives.
Page 3 STARTING THE COMPRESSOR. fig. 3 DO NOT, NOTE: WARNING! For this reason DO NOT tamper with, or adjust, the switch or safety valve. MAINTENANCE WARNING! Before performing any maintenance operation, switch off the compressor, disconnect from electricity supply and release all air from the tank. IMPORTANT! Failure to carry out maintenance tasks may invalidate the warranty on your compressor.
Page 4 DIRECT DRIVE COMPRESSOR Models: SA22503 For Jack Sealey Ltd. Sole UK importer of Sealey Power Products. NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.