Sealey SA22420 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1. ELECTRICAL SAFETY. p
You must check all electrical equipment and appliances to ensure they are safe before using. You must inspect power supply leads, plugs and
all electrical connections for wear or damage. You must ensure the risk of electric shock is minimised by the installation of appropriate safety
devices. An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD
(Residual Current Device) is used with all electrical products. It is particularly important to use an RCD with portable products that are plugged
into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You may obtain a Residual Current Device by
contacting your Sealey dealer. You must also read and understand the following instructions concerning electrical safety.
1.1.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a
qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.1.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those appliances
and the safety of appliance operators. If in any doubt about electrical safety, contact a qualified electrician.
1.1.3. Ensure the insulation on all cables and the product itself is safe before connecting to the mains power supply.
See 1.1.1. & 1.1.2. above and use a Portable Appliance Tester (PAT).
1.1.4. Ensure that cables are always protected against short circuit and overload.
1.1.5. Regularly inspect power supply leads and plugs for wear or damage and connections to ensure that none is loose.
1.1.6. Important: Ensure the voltage marked on the product is the same as the power supply to be used, and check that the plug is fitted with the
correct capacity fuse.
1.1.7. DO NOT pull or carry the appliance by its power supply lead.
1.1.8. DO NOT pull plug from socket by the power cable.
1.1.9. DO NOT use worn or damage leads, plugs or connections. Immediately replace or have repaired by a qualified electrician.
1.1.10. This device is fitted with a ASTA/BS approved non-rewirable plug.
If the plug is damaged it should be replaced according to the instructions below.
(UK only - see diagram at right). Ensure the unit is correctly earthed via a three-pin plug.
a) Connect the green/yellow earth wire to the earth terminal ‘E’.
b) Connect the brown live wire to the live terminal ‘L’.
c) Connect the blue neutral wire to the neutral terminal ‘N’.
d) Ensure the plug is fitted with a 13 amp fuse.
e) After wiring, check that there are no bare wires, that all wires have been correctly
connected, that the cable outer insulation extends past the cable restraint and that the
restraint is tight.
1.2. GENERAL SAFETY INSTRUCTIONS
Familiarise yourself with the application and limitations of the compressor.
3
Ensure the compressor is in good order and condition before use. If in any doubt do not use the unit and contact an electrician/service agent.
3
WARNING! Compressor must only be serviced by an authorised agent. DO NOT tamper with, or attempt to adjust, pressure switch or safety valve.
p
Before moving or maintaining the compressor ensure that it is unplugged from the mains supply and that the tank pressure has been vented.
p
3
Only use recommended attachments and parts. To use unauthorised items may be dangerous and will invalidate your warranty.
3
Read the instructions regarding any accessory used with the compressor. Ensure the safe working pressure of any air appliance used exceeds the
3
compressor output pressure. If using a spray gun, check that the area selected for spraying is provided with air change system/ventilation.
Ensure the air supply valve is turned off before disconnecting the air supply hose.
3
Use the compressor in a well ventilated area and ensure it is placed on a firm surface.
3
Keep tools and other items away from the compressor when it is in use and keep area clean and clear of unnecessary items.
3
Ensure the air hose is not tangled, twisted or pinched.
3
Keep children and unauthorised persons away from the work area.
3
DO NOT dis-assemble compressor for any reason. The unit must be serviced by qualified personnel only.
7
DO NOT use the compressor outdoors, or in damp, or wet, locations and DO NOT operate within the vicinity of flammable liquids, gases or solids.
7
DO NOT touch compressor cylinder, cylinder head or pipe from head to tank as these may be hot and will remain so for some time after shutdown.
7
DO NOT attempt to move the compressor by pulling the air tool hose.
7
DO NOT use the compressor for a task for which it is not designed.
7
DO NOT cover the compressor or restrict air flow around the machine whilst operating.
7
DANGER! DO NOT direct the air hose towards people or animals.
s
DO NOT operate the compressor without inlet air filter.
s
7
DO NOT allow anyone to operate the compressor unless they have received full instructions.
7
WARNING! The air tank is a pressure vessel and the following safety measures apply:
p
DO NOT tamper with the safety valve, DO NOT modify or alter the tank in any way and DO NOT strap anything to the tank.
p
DO NOT subject the tank to impact, vibration or to heat and DO NOT allow contact with abrasives or corrosives.
DO drain condensation from tank daily, inspect inside walls for corrosion every three months and have a detailed tank inspection
carried out annually.
The tank shell must not fall below the certified thickness at any point.
WARNING! If an electrical fuse blows, ensure it is replaced with an identical fuse type and rating.
p
When not in use, store the compressor in a safe, dry, childproof location.
p
3
WARNING! It is the user’s responsibility to read, understand and comply with the following:
p
INSTRUCTIONS FOR:
2.0HP OIL FREE DIRECT DRIVE COMPRESSOR
SA22420
Model:
Yellow & Green
Earth Wire
Blue
Neutral
Wire
Cable
Restraint
SA22420 - 2 - 281005
Brown
Live
Wire