Backend Ic And Camera Module Clocks; Flash Programming Error Codes - Nokia 6088 Baseband Description And Troubleshooting

6088 (RM218)
Baseband Description and Troubleshooting
The system clock is stopped during sleep mode by disabling the VREG_TCXO.
The TCXO is turned off by the PMIC regulator, which is from MSM's TCXO_EN
output signal.

Backend IC and Camera Module Clocks

Figure 10: backend IC and camera module clocks
Backend IC (U200) uses external 13MHz crystal (Y210) and internal PLL to generate
internal clocks. Backend IC provides 24MHz clock to camera module. Camera
module uses the 24MHz clock to generate 12MHz pixel clock.
Flash Programming Error Description
This table describes the error condition during Flash memory downloading to the mobile
terminal.
Description
Packet Checksum fail
Erase fail
Write fail
Page 16 © 2006 Nokia Corporation
Not Working Properly
ERR: CRC invalid
Unable to erase device
Write unsuccessfully
Figure 11: Flash Programming Error Description
Company Confidential Issue 1 10/2006