Inalto ARBC90TPS User Manual page 13

– Electric cooktops must have a minimum height of
e wall ensuring that it's secured in a level
600mm from the underside of the rangehood to the
as much as possible,
600mm from the underside of the rangehood to the
, Tighten the bracket with the screw plug and
cooktop face.
wherever possible
cooktop face.
ST4mm X 30mm).
– Gas cooktops must have a minimum of 650mm from
ere using the shortest
– Gas cooktops must have a minimum of 650mm from
nished, line up the hood and hang onto the
the burner to the underside of the rangedhood.
the burner to the underside of the rangedhood.
cket hook. (See pic A )
– It is not recommended to install the rangehood
ever possible
– It is not recommended to install the rangehood
he extensible 150mm tube to the canopy.
outside or over open flame grillers or barbecues.
outside or over open flame grillers or barbecues.
nside chimney with the outside chimney
r, ensure that the inner chimney piece can
eely inside. Now attach the chimney to the
s, Airvolution
mark the hole and drill 2 holes, then tighten
Figure A
s to be mounted
ide chimney bracket with screw plug and
00mm above the
ST4mm X 30mm). (See pic B )
eed the safety screws fixed into the hood,
a minimum height of
mark, drill and tighten the hood with screw
f the rangehood to the
d screw (ST4mm X 30mm). Note, you will
remove the grease filters first. (See Pic C )
nimum of 650mm from
e inner chimney to adjust the inner chimney
f the rangedhood.
When the height you required is reached,
all the rangehood
and accommodate the inner chimney bracket
illers or barbecues.
ew plug and screw (ST4mm X 30mm).When
, fix the inner chimney with the screws (4mm
Figure B
to the inner chimney bracket . (See pic C )
o install the screws or fixing device in
nce with these instructions may result in
al hazards. The warning shall be in the same
he instructions that include details of how
nt the equipment.
Figure C
move freely inside. Now attach the chimney to the
hood. When finished, fix the outside chimney to the
canopy, mark the hole and drill 2 holes, then tighten
the outside chimney bracket with screw plug and
screw (ST4mm X 30mm). (See pic B )
If you need the safety screws fixed into the hood,
please mark, drill and tighten the hood with screw
plug and screw (ST4mm X 30mm). Note, you will
need to remove the grease filters first. (See Pic C )
– Slide the inner chimney to adjust the inner chimney
height. When the height you required is reached,
mark it and accommodate the inner chimney bracket
with screw plug and screw (ST4mm X 30mm).When
finished, fix the inner chimney with the screws (4mm
X 8mm) to the inner chimney bracket . (See pic C )
Warning
Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards. The warning shall be in the same
part of the instructions that include details of how
to mount the equipment.
8
13
finished, fix the inner c
X 8mm) to the inne
X 8mm) to the inner c
Warning
Warning
Failure to install the
Failure to install the sc
accordance with th
accordance with thes
electrical hazards. T
electrical hazards. The
part of the instruct
part of the instruction
to mount the equip
to mount the equipme
8
8