Table of Contents
Advertisement
Installation Instructions (Continued)
INSTALLATION STEPS
• Once you've determined your installation height, drill 3 holes to install the mounting
bracket (hook) onto the wall ensuring that it's secured in a level position. Tighten the
bracket with the screw plug and screw (ST4mm X 30mm).
• When finished, line up th0e hood and hang onto the wall bracket hook (See Figure A).
• Attach the extensible 150mm tube to the canopy. Put the inside chimney with the
outside chimney together, ensure that the inner chimney piece can move freely inside.
Now attach the chimney to the hood. When finished, fix the outside chimney to the
canopy, mark the hole and drill 2 holes, then tighten the outside chimney bracket with
screw plug and screw (ST4mm X 30mm) (See Figure B ).
• If you need the safety screws fixed into the hood, please mark, drill and tighten the
hood with screw plug and screw (ST4mm X 30mm). Note, you will need to remove the
grease filters first (See Figure C ).
• Slide the inner chimney to adjust the inner chimney height. When the height you
required is reached, mark it and accommodate the inner chimney bracket with screw
plug and screw (ST4mm X 30mm). When finished, fix the inner chimney with the
screws (4mm X 8mm) to the inner chimney bracket (See Figure C ).
12
Advertisement
Table of Contents
