D-Link DAP-X1860 Quick Installation Manual

Quick Installation Guide
DAP-X1860
AX1800 Mesh Wi-Fi 6 Range Extender

INSTALLATION

OPTION 1

QUICK WPS SETUP

You easily can pair your device with any router to extend your wireless
network.
1
Plug the DAP-X1860 into a power source near your wireless router.
Wait until the LED starts blinking orange.
/
2
Press the WPS button on your router for 3 seconds. Refer to your
/ router's manual for router behaviour.
3
Press the WPS button on your DAP-X1860
/ for 2-3 seconds. The status LED should start
to blink green.
4
When the Status LED turns solid green (may
/ take up to 5 minutes), this indicates that
your DAP-X1860 is securely connected to
your wireless router.
Your setup is complete! You can now unplug and move your device to
a location between your router and the area where you want wireless
coverage. By default, your device will share the same Wi-Fi name and
password as your router.
IMPORTANT
WPS may be disabled on some Routers or Modems. If the WPS Status
LED on your Router or Modem does not start blinking when you have
pressed the WPS button, try again and hold it a little longer. If it still
does not blink, STOP, and configure your DAP-X1860 using
Option 2: D-Link Wi-Fi App Setup.

PACKAGE CONTENTS

• DAP-X1860 || AX1800 Mesh Wi-Fi 6 Range Extender
• Quick Installation Guide
• Quick Installation Card
OPTION 2

D-LINK WI-FI APP SETUP

1
Download the D-Link Wi-Fi app and launch it.
/
D-Link Wi-Fi
2 Tap Install New Device. Scan the QR code on the Quick
Installation Card. Follow the on-screen instructions to complete
/
the setup.
D-Link Wi-Fi
QUICK INSTALLATION CARD
SETUP QR CODE
Model Name: DEVICE
Wi-Fi Name: dlink-XXXX
Password: XXXXXXXX
S/N: 123456789
www.dlink.com