During Recording - LogTag Recorders USRID-16W Product User Manual

Operating the Logger
The delay time is shown in hours and minutes. The time counts down and the USRID-16W
starts recording when it reaches 0 00.
The logger will not start
if you release the button while the
l
if you keep holding the button for more than 2 seconds after the
l
remains permanently on.

During Recording

During normal operation, the display shows the most recently recorded temperature. The
elapsed time since the start of the trip is also displayed - in hours and minutes for the
first 24 hours, and in days and hours thereafter. A tick symbol
alarm event has occurred.
Temperatures are shown in Celsius.
The temperature unit on the display is the same as used for the PDF and CSV files.
For USRID-16W1 and USRID-16W2 loggers, this is pre-set to °C in the factory.
An alarm was triggered
If an alarm event occurred, the alarm indicator
displayed in the bottom left corner, as shown.
Additionally, one or more of the alarm threshold arrows
( ) indicate, which of the alarms were triggered.
In the example, the primary upper alarm was triggered,
with cumulative temperatures exceeding 30 °C for more
than 10 hours.
Marking a reading with an inspection mark
When you press the
reading taken will be identified in the downloaded data and on the PDF report with an
inspection mark.
Power Save
For USRID-16W loggers,
automatically switches off if none of the buttons have been pressed for 30 seconds.
USRID-16W User Guide
button while the USRID-16W is recording, the next
START
/Mark
Power Save is enabled until the device is started. The display
symbol is still flashing; or
is
symbol
is shown as long as no
16