Roland V-Studio 100 Manual page 3

Channel Strip Section
This section is used to control the parameters for the tracks and buses
of Logic Pro/Express and GarageBand.
1. Track selection button
Use this button to select the track (or bus) to control.
You can determine whether the current strip is to be made a track or
the MASTER bus by holding down the [SHIFT] button while you press
the Track Select button.
2. [ASSIGN] button
Press the [ASSIGN] button repeatedly to cycle through the various
functions that can be assigned to the [VALUE] knob.
The currently assigned parameter is displayed on the screen (p. 2).
Music production
Pan
software
Logic Pro/Express Pan
GarageBand Pan
MEMO
Functions cannot be assigned to the MASTER bus.
3. [VALUE] knob
Use this knob to change the value of the current parameter.
4. Channel fader
Use this to control the volume of the current strip.
The channel fader has a touch-sensitive motor fader so it can move
in response to the volume of the current strip. It also moves while
playing, according to the automation information.
To record automation information, touch and then release the fader
during automation recording.
MEMO
For more information about recording automation information, see
the Logic Pro/Express or GarageBand online Help.
Send1 Send2
Send 1 Gain Send 2 Gain
Level of signal Level of signal
sent to ECHO. sent to REVERB.
Using a VS-100 to Control Logic Pro/Express or GarageBand
5. [MUTE] button
Press this button to turn the mute on or off for the current strip.
When the current strip is muted, the [MUTE] button is lit.
Input monitoring for the current strip can be switched on/off by
holding down the [SHIFT] button while you press the [MUTE] button.
* When the current strip is the bus, this does not work.
* Functions only with Logic Pro/Express.
6. [SOLO] button
Press this button to turn the solo on or off for the current strip.
When the current strip is the solo, the [SOLO] button is lit.
You can switch Solo on/off for all tracks by holding down the [SHIFT]
button while you press the [SOLO] button.
7. [ARM] button
Press this button to turn recording standby on or off for the current
strip.
When the current strip is in recording standby mode, the [ARM] button
is lit.
* When the current strip is the bus, this does not work.
When recording automations, the current strip can be placed in
recording standby by holding down the [SHIFT] button while you
press the [ARM] button.
* Functions only with Logic Pro/Express.
8. [SHIFT] button
Use this button in combination with other buttons.
3