KAPSCH Janus HOTPass Mounting Instructions

Kapsch Tra cCom
Janus HOTPass
®
Mounting Instructions
HOV Lane Switch Position
The HOTPass interior transponder mounts on the vehicle windshield. The preferred mounting
®
location is between the roo ine and the rear view mirror post. If there is not enough room in the
preferred mounting location to accommodate the HOTPass
mounted beside the rear view mirror post. The HOTPass
Lock fasteners.
™
Requirements
WARNING: For safety purposes, select and move the
switch into the desired position and function only when
the vehicle is standing, parked or otherwise not in mo-
tion; failure to heed this warning may result in serious
injury or death.
For reliable operation of the transponder, the vehicle must be

equipped with only one transponder while passing through a toll
facility. Other transponders present in or on the vehicle must be
switched o or enclosed in an RF shield.
The mounting location must provide direct line-of-sight

communication between the transponder and the toll facility
overhead antenna.
Do not mount the HOTPass

transponder on vehicles:
®
Interior Transponder
®
®
with non-metallic roofs.

with windshields covered in RF-blocking material (ex. metal oxide).

with a metallic center windshield dividing post.

without center-mounted rear view mirrors.

Handheld mobile communication devices must not be located within

12 in. of the transponder.
Metal objects (except for the rear view mirror and the roof) must not

be located within 6 in. of the transponder.
HOTPass

®
prohibit mounting transponders on the windshield.
Apply Dual Lock

70 - 0709-4029-4.
Standard Toll Switch
transponder, the transponder can be
®
transponder is secured using 3M
transponders cannot be used where local regulations
fasteners in accordance with 3M
™
Dual
™
document.
™