2.3 System Protection
Your turbine comes equipped with state of the art overcharge protection.
When the temperature of the turbine exceeds 80°C (176°F) your turbine
will automatically shut down and apply the braking system to your wind
turbine to prevent damage.
High battery voltage protection
Over charging current protection
Over-speed protection
Overheat protection for generator
Caution 1 : Any under sizing of wire can be potentially dangerous; our
warranty doesn't cover damage caused by improper use of wire gauge.
Caution 2 : Please review the following wire gauge table to install the
correct wire gauge.
We recommend these as the minimum wire sizes for optimal
performance for the distance from your turbine to the battery.
Always use the largest gauge wires that are practical and affordable.
Local, state, and or national electrical codes take precedence over these
general recommendations.
12V Volt Systems, AWG / Metric Wire Size mm
0-10M
2
14 / 2 mm
12 / 3.5 mm
10-20M
20-30M
2
10 / 5.5 mm
14.8V
≤1200 rpm
≤900 rpm and 70 sec.
2
30-45M
2
8 / 8 mm
5
20A
45-75M
2
6 / 14 mm
2
Need help?
Do you have a question about the 400 Watt Turbine and is the answer not in the manual?