Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CTR 10 000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for CorroVenta CTR 10 000

  • Page 2: Table Of Contents

    Safety information ..........................4 How the dehumidifier works ....................... 5 Product Overview ..........................6 Installation ............................7 Installation Instructions ........................8 Accessories and consumables ......................16 Troubleshooting ..........................17 Technical data ........................... 18 © Corroventa Avfuktning AB 2020.12 1 (18)
  • Page 3: Intended Use

    The trailer allows both crane lift as well as forklift transportation, and as it can be used both indoors and outdoors, the CTR 10000 is truly deployable, readily and easily used where ever required. As all other Corroventa machines, the CTR 10000 is very energy efficient. Features •...
  • Page 4: Waiver Of Liability

    Corroventa Avfuktning AB. Any comments on the contents of this document shall be sent or addressed to:...
  • Page 5: Safety Information

    19. The dryer must never be used with any other accessories than those listed in this manual or those specifically approved by Corroventa Avfuktning AB. For further advice on product safety and use, please contact the supplier. © Corroventa Avfuktning AB 2020.12...
  • Page 6: How The Dehumidifier Works

    Although much larger and with much higher capacity, the CTR 10000 works according to the same principles as the portable adsorption dryers of the Corroventa product range. The rotor is coated with Silica Gel, a crystal with enormous amounts of microscopic pores which makes its total surface very large.
  • Page 7: Product Overview

    User Manual CTR 10000 Product Overview Regeneration Air Inlet Hatch Dry Air Outlet Process Air Intake Wet Air Outlet Control panel located on side door. Air hoses together with power cables are stored in this compartment. © Corroventa Avfuktning AB 2020.12 6 (18)
  • Page 8: Installation

    When used indoors, the wet air is evacuated through a wet air hose led through window or other opening. The condensate hose depicted in illustrations below is only valid for the A50 TD2. Outdoor use Indoor use © Corroventa Avfuktning AB 2020.12 7 (18)
  • Page 9: Installation Instructions

    User Manual CTR 10000 Installation Instructions Open reg air hatch and remove sleeves for dry air. Open hatch for process air and remove sleeve for wet air. Connect dryer to 400V 63A with 63A cable. © Corroventa Avfuktning AB 2020.12 8 (18)
  • Page 10 User Manual CTR 10000 For startup, follow the instructions below (this information can also be found on a sticker inside the unit, below the control panel) © Corroventa Avfuktning AB 2020.12 9 (18)
  • Page 11 If you need, connect dry air hoses. Try to create rotation in dry air at the place you will dry, use the hoses. Connect wet air hose. IMPORTANT! If dryer is placed indoor, you must lead out the wet air outdoor. © Corroventa Avfuktning AB 2020.12 10 (18)
  • Page 12 Make sure to change filter at regular intervals depending on where the dryer operates. This is process air filter. (Art no. 05111). Make sure to change filter at regular intervals depending on where the dryer operates. This is the reg air filter. (Art no. 05110). © Corroventa Avfuktning AB 2020.12 11 (18)
  • Page 13 The CTR 10000 allows for transportation with a forklift. Follow the steps below to unload it from the trailer. 1. There are four container locks, one in each corner. Unscrew all of them until they fall to the unlocked position. © Corroventa Avfuktning AB 2020.12 12 (18)
  • Page 14 2. Make sure that the container locks are all the way down. They should be flush with the trailer bed. 3. Open the back gate and pull out the ramps. Unhook the two latches in the front. This enables the trailer to be tilted. © Corroventa Avfuktning AB 2020.12 13 (18)
  • Page 15 User Manual CTR 10000 5. Pull out the two support legs in the rear. Tilt the trailer until the support legs touch the ground. 7. Place the ramps in the designated cutouts on the trailer. © Corroventa Avfuktning AB 2020.12 14 (18)
  • Page 16 User Manual CTR 10000 Unlock the pulley and start unloading the CTR 10 000. It might need a light push to get started. © Corroventa Avfuktning AB 2020.12 15 (18)
  • Page 17: Accessories And Consumables

    User Manual CTR 10000 Accessories and consumables The following articles are available as accessories and consumables to the CTR 10000: Article number Name 01100 Humidistat, HR1-5 05111 Process air filter 05110 Regeneration Air Filter © Corroventa Avfuktning AB 2020.12 16 (18)
  • Page 18: Troubleshooting

    If the machine is overheated it stops and the red lamp (no. 11 on electric cabin) will light up. Let the machine cool, make sure hatches are open, change filters. Open the back doors and reset the red buttons. © Corroventa Avfuktning AB 2020.12 17 (18)
  • Page 19: Technical Data

    Capacity +20°C, 80% RF 875 l/day Size H 1,80 x B 1,70 x L 3,00 m Weight 1080 kg Weight with trailer 1560 kg Size incl. trailer H 2,20 x W 2,33 x L 4,85 m © Corroventa Avfuktning AB 2020.12 18 (18)
  • Page 20 In emergency situations and during flooding, CORROVENTA LTD Corroventa’s customers have access to one of the largest rental parks in Europe. Unit 47, Melford Court, Hardwick Grange, Warrington All our products are manufactured in Bankeryd, Sweden.

Table of Contents