Huawei B2368 User Manual page 38

LTE CPE B2368
User Guide
Figure 4-2 Network Setting > Broadband > Broadband > Edit
The following table describes the fields in this screen.
Table 4-2 Network Setting > Broadband > Broadband > Edit
Label
Name
Auto APN
APN
MTU
NAT Enable
IP Pass Through
Issue 03 (2019-01-31)
Description
This shows the name of the broadband connection.
Select this to have the LTE Device configure the APN (Access Point
Name) of the LTE network automatically. Otherwise, enter the APN
manually in the field below.
Enter the Access Point Name (APN) of an LTE network, which your
service provider gave you.
The Maximum Transmission Unit (MTU) defines the size of the largest
packet allowed on an interface or connection. Enter the MTU for this
WAN interface in this field.
Select this to activate NAT on the WAN.
Select this to allow the ISP to assign IP addresses directly to the LAN
devices. This disables NAT and DHCP server configuration (Network
Setting > Home Networking > LAN Setup). The LTE Device will be
remotely managed by HTTPS and SNMP. Choosing this option also
displays more IP pass through configuration parameters.
Copyright © Huawei Technologies Co., Ltd.
4 Broadband
30