Table of Contents
Advertisement
The glass is being
scratched.
Some pans make
crackling orclicking
noises.
8. Installation
8.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work
surfacematerial to avoid larger deformation caused by the heat radiation from the hotplate.As shown
below:
L(mm)
W(mm)
H(mm)
590
520
55
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet and outlet
are not blocked. Ensure the ceramic cooker hob is in good work state. As shown below
Note: The safety distance between thehotplate and the cupboard above thehotplate should be at
least 760mm.
Rough-edged cookware.
Unsuitable, abrasive scourer or
cleaning products being used.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
D(mm)
A(mm)
51
560+4
+1
Use cookware with flat andsmooth
bases. See 'Choosingthe right
cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
B(mm)
X(mm)
490+4
50 mini
+1
16
Advertisement
Table of Contents
