General Voltage Checking - Nokia 6120 classic Service Manual

General voltage checking

Steps
1. Set up the main board in the module jig. The phone should be in local mode.
2. Check the following:
#
1 VCTCXO supply
2 AHNEUS supply from DC/DC conv
3 FEM supply
4 WCDMA PA supply from DC/DC conv
5 Vbat at WCDMA PA
6 Supply input to DC/DC conv
* With these settings, the result should be 1.3 V.
Page 4 –8
Signal name
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
Test point
R7501 2.5 V
C7590 3.2 V
L7510 3.9 V
C7543 0 V (1.3 V* when transmitting. Settings
as in note below)
C7547 3.9 V
L7592 3.9 V
RF troubleshooting
Voltage (all bands)
RM-243
Issue 1