Table of Contents
Advertisement
Confidential
Chapter 3
Software
Required Software to use the USB Interface Function of the UB-U90
When using the USB interface function of the UB-U90, you need one of the following drivers.
Contact your dealer to find out the compatible printers and how to get the software.
❏ OPOS
❏
Advanced Printer Driver
Installation Procedure
The installation procedure is as follows. If you plan to use the serial interface only, this
procedure is not necessary.
1. Confirm the BIOS settings.
2. Install the driver. (See the instructions to install the driver you plan to use.)
Confirming the BIOS settings
Make sure that the USB is set to Enable in BIOS setting of the PC. If it is set to Disable, USB is not
available.
Installing OPOS
1. First, prepare a blank FD. Start the steps below while the TM printer and PC are not
connected.
2. Install OPOS following the Installation Wizard. See the OPOS manual packed with the
Install Disk for details.
3. The device driver [TMUSB90.SYS] and [TMUSB90.INF] are saved in the folder in which
OPOS is installed. Save them to the FD.
4. Connect the printer with UB-U90 attached to PC while the printer is off.
5. Turn on the printer. Installation starts by Plug and Play feature.
6. When the message [This wizard searches for new drivers for] appears, click Next.
7. [What do you want Windows to do?] appears. Then select [Search for the best driver for your
device. (Recommended)] option and click Next.
8. Check the Specify a location check box then click Browse.
Rev. B
UB-U09 Developer's Guide
Software 3-1
Advertisement
Table of Contents
