Radial Engineering JX44 V2 Owner's Manual page 5

True to the Music
REAR PANEL FEATURES
8 9
8. IEC POWER: Connection for standard IEC power cable (included). 100/240V operation for international use.
9. MIDI IN: Standard 5-pin MIDI connector allows MIDI controllers to activate the inputs and outputs of the JX44 V2. Eight dip
switches configure channel, program, and control changes. Can be used in conjunction with JR-5 remote footswitches.
10. REMOTE FOOTSWITCH: XLR connections for optional JR-5 remote footswitches, which can control either the instrument inputs
or the amplifier outputs. Two JR-5 footswitches can be used simultaneously.
11. TUNER OUT: Buffered unbalanced output to feed a separate tuner. This output is fed by all inactive instrument inputs, and will
always be active even if the Mute switch is engaged.
12. EFX LOOP REMOTE: 1/4" TRS jack for connection to standard momentary footswiches to turn on/off the EFX Loop remotely or
mute the outputs of the JX44.
13. OUTPUTS 1-4: Transformer isolated and buffered gold-contact outputs for feeding up to four stage amplifiers.
14. STEREO EFX LOOP: 1/4" TS send and receive connections for local effects pedal chains.
15. DIRECT OUTPUT: Balanced XLR output to feed a mixer or recording interface. Lift switch disconnects pin-1 to eliminate hum and
buzz. Assign switch selects whether the Direct Out is fed a pre or post-EFX signal, or instrument input 4 exclusively.
16. SGI RX/TX: Balanced SGI loop works with the optional SGI-44 to drive long cable runs to and from a remote pedalboard. Includes
ground lift switch and SGI on/off switch.
17. INPUTS 1-4: Connections for unbalanced instruments such as guitars and basses. Wired in parallel with front panel connectors.
Radial Engineering Ltd.
11
10 12 13
JR-5 Remote:
Optional accessory
to control either
guitar or amplifier
switching.
14 15 16
SGI-44 Interface:
Optional accessory
to connect a remote
pedalboard to the
JX44.
17
4
JX44 V2™ Owner's Manual