Contour Core Sculpting System User Manual page 18

1. Get Ready
This quick start will guide you through the set-up
of your Contour Core Sculpting System. Please
read through the rest of this manual before you
begin your workout.
1. Insert 4 AAA batteries.
Open the battery compartment pulling back
on the tab and lifting the cover off. Insert
batteries as shown inside battery compartment.
Replace the battery cover. (See fig. 1)
2. Slide the Lead Wire Module onto the M1 Muscle
stimulator device until it clicks. (See fig. 2)
3. Slide the end of the lead wires to the holes on
the inside of the Contour CoreBelt
Note: The two snaps on the lead wires need to
be positioned on the same side of the belt.
Repeat for all 4 snap heads.
4. Snap the end of the lead wires to the buttons on
gel pads. (See fig. 4)
5. Remove the paper liner from the front of gel
pad. This is the side with the snap (See fig. 5)
6. Place gel pad down on the back of the Contour
CoreBelt so it's inside the white oval.
™
Repeat for all 4 gel pads. (See fig. 6)
fig. 1
fig. 2
(See fig. 3)
™
fig. 5
fig. 3
fig. 4
fig. 6
19