Chicco AUTO SAFARI Instruction Manual page 9

• To adjust the volume level, move the switch F (Diag. 4) from the <)) (low) position to the <)))
(high) position.
• In order to avoid using up the batteries for no reason, it is recommended to switch off the toy by
moving the switch E (Diag. 4) to the 0 position.
1.5
• Insert the batteries in the walkie-talkie style infrared remote control before using it; it only works
this
when the toy panel is set to Fun mode.
em
• To start the game functions, point the sensor on the infrared remote control at the panel (Diag.
4.1).
Play modes
e.g.
1. RELAX: to enable this play mode, move the switch E (Diag. 4) to the I position.
The low lights and soft music gently soothe your baby. The infrared remote control does not work
tly.
when the toy is operating in this play mode. The toy will switch off automatically after 15 minutes.
To restart it, switch it off by moving the switch to the 0 position. Then switch it back on and set
the desired play mode.
2. FUN: to enable this play mode, move the switch E (Diag. 4) to the II position. A jingle will con-
firm the play mode choice. When set to Fun mode, every time the child presses one of the buttons
y to
on the infrared remote control (Diag. 5) the relative sound effect will play. If the same button is
pressed a number of times, a tune will play. In both cases, the images linked to the buttons will be
t or
displayed on the panel so your baby will learn to recognise them. When set to FUN mode, if the
toy is not used for about 20 minutes, it will play a sound effect and switch off automatically. To
trol
restart it, switch it off by moving the switch to the 0 position. Then switch it back on and set the
play mode of your choice.
the
the
HOW TO FIT AND REMOVE THE REPLACEABLE BATTERIES
• To replace the panel batteries: loosen the screw on the battery compartment cover (G, Diag. 6)
on the back with a screwdriver and remove the cover; then remove the flat batteries and fit new
ones, ensuring that the battery polarity is correct (as shown on the product), close the battery
on compartment cover, and tighten the screw firmly.
• To replace spent batteries inside the infrared remote control: open the velcro fastener on the
back, loosen the screw on the battery compartment cover (H, Diag. 7) on the back with a screw-
driver and remove the cover; then remove the flat batteries and fit new ones, ensuring that the
iag. battery polarity is correct (as shown on the product), close the battery compartment cover, and
hen tighten the screw firmly. Close the velcro fastener firmly when you have finished changing the
batteries.
WARNING
• Batteries must only be fitted by an adult.
• Always keep batteries and tools out of the reach of children.
• Always remove spent batteries from the toy to avoid the danger of leakage from the battery
ion damaging the product.
• Always remove the batteries if the product will not be used for a long period of time
9