Chicco AUTO SAFARI Instruction Manual page 8

GB USA
Instruction manual
Age: 12 Months +
• Please read these instructions carefully before using the toy and keep for future reference.
• The toy is battery operated as follows: 3 x 1.5 Volt AA batteries for the panel (included), 2 x 1.5
Volt AAA batteries for the infrared remote control (included). The batteries supplied with this
product, at the point of sale, are intended for demonstration purposes only; please replace them
immediately after completing your purchase.
WARNINGS
For your child's safety: WARNING!
• Before using the product remove and dispose of any plastic bags and any other packaging (e.g.
fasteners and fixing ties etc) and keep them out of reach of children. Suffocation hazard.
• Check the toy regularly for signs of wear and damage and to ensure that it is assembled correctly.
Should any part be damaged, do not use the toy and keep it out of reach of children.
• This toy must only be used under adult supervision.
• Always use the toy with the child car seat facing forwards.
• This car panel must only be assembled and fitted by an adult.
• The panel can only be installed on the back of front car seats which have a head rest.
• Make sure the panel is fitted correctly and firmly attached to the head rest. Check it regularly to
ensure it has not come loose.
• Never leave the panel on a vehicle seat without fastening it securely in place; it could hurt or
injure other passengers in the car.
• Remember never to turn your head to switch the toy on, or pick up the infrared remote control
while you are driving the car.
• When the rear seat is empty, the infrared remote control can be fastened to the panel using the
relative slot. When the child is sitting in the car seat, fasten the infrared remote control to the
child car seat harness only.
• This product must not be modified in any way; never fasten other ties or straps to it.
INSTALLING THE PANEL IN THE CAR
Open the buckles (A. Diag. 1) found on the back of the panel and fasten them to the supports on
the head rest. Pull the straps (B, Diag. 2) to fasten the panel firmly to the seat.
FASTENING THE INFRARED REMOTE CONTROL TO THE CAR SEAT
Fasten the infrared remote control (C, Diag. 3) to the child car seat safety harness strap (D, Diag.
3) using the velcro fastener strap. This aims to prevent the toy from falling onto the floor when
travelling by car.
HOW TO USE THE TOY
Switching it ON and Off
• To switch the toy panel ON, move the switch E (Diag. 4) from the 0 position to the I position
(Relax) or II (Fun) position according to the game mode desired.
SAFARI CAR TOY
8
• To
(h
• In
m
• In
w
• To
4.1
Pla
1. R
The
wh
To
the
2.
firm
on
pre
disp
toy
rest
pla
HO
• To
on
on
co
• To
ba
dr
ba
tig
ba
W
• Ba
• Al
• Al
da
• Al