Minolta DYNAX 9 Ti Instruction Manual page 9

CUSTOM FUNCTIONS
4 – Exposure Compensation Using Rear Control Dial - (P
with Front Control Dial in P Mode)
Changes the tasking for the rear control dial to exposure compensation.
• The exposure compensation value is displayed in the meter index.
• Exposure compensation dial must be set to +/– 0.
• Compensation range is +/– 3 EV for both 1/2 and 1/3 EV increments.
• The bottom display in the viewfinder does not show the marks "+" or " _ ".
Exposure
Mode Front Control Dial
P - Mode Ps - shutter speed
A - Mode Aperture
S - Mode Shutter speed
16
Mode
S
Control Dial Tasking
Rear Control Dial
Exposure
compensation
Cust 18-2 Creative Program
P / Ps Mode Operation
A
After the AE system has been activated, you can change the shutter speed or
aperture selected by the camera. Creative program remains active until the data
panel display disappears.
Custom Function Notes
Refer to page 13 to change the data panel display duration.
While the aperture/shutter speed are displayed in P-mode...
• The aperture and shutter speed change in 1/2 or 1/3 EV increments depending on the
position of the exposure compensation dial.
• Flash can not be used with the P and P
A
- Built-in and accessory flashes will not fire when the P
- P and Ps modes can not be selected when
A
• If the shutter speed or aperture blink, the required setting is not available. Turn the control
dial until the blinking stops.
Cancelling P / Ps Mode
A
Wait until the displayed data disappears from the data panel or raise
the built-in flash.
Turn the front control dial to change
the shutter speed.
• Aperture is adjusted automatically.
Turn the rear control dial to change the
aperture.
• Shutter speed is adjusted automatically.
modes.
S
and Ps modes are active.
A
appears in the viewfinder.
17