Rack Mounting - Infinite TRANSTECTOR TT-DT10-2G-8GP+ User Manual

Step 1: Attach the rubber feet to the recessed areas on the bottom of the GSD-1008HP, as shown below.
Step 2: Place the TT-DT10-2G-8GP+ on a desktop near an AC power source.
Step 3: Keep enough ventilation space between the TT-DT10-2G-8GP+ and the surrounding objects to allow
for air flow.
When choosing a location, please keep in mind the environmental restrictions discussed
in Chapter 1, Section 4, under Specifications.
Step 4: Connect your TT-DT10-2G-8GP+ to 802.3af/802.3at complied power devices (PD) and other network
devices. Connect one end of a standard Ethernet network cable to the 10/100/1000BASE-T RJ45 ports on the
front panel of the TT-DT10-2G-8GP+. Connect the other end of the cable to the network devices such as
printer servers, workstations, routers, cameras, IP phones, etc.
Step 5: Supply power to the TT-DT10-2G-8GP+. Connect one end of the power cable to the Switch
connect the power plug of the power cable to a standard wall outlet.
When the TT-DT10-2G-8GP+ receives power, the Power LED should remain solid Green.

3.2 Rack Mounting

To install the TT-DT10-2G-8GP+ a 19-inch standard rack, follow the instructions described below.
Step 1: Place your TT-DT10-2G-8GP+ on a hard, flat surface, with the front panel positioned towards your
front side.
Step 2: Attach a rack-mount bracket to each side of the TT-DT10-2G-8GP+ with the supplied screws as
shown below.
Attaching the Rubber Feet to the TT-DT10-2G-8GP+
and