Table of Contents
Advertisement
ED5800 (A) Series
Concealed Vertical Rod Exit Devices
Installation Instructions
9
Install Rods
A. Slide rod assemblies into door. (Figure 15)
B. Attach top latch with six (6)
#10-24 X 1/2" PFHMS.
C. Install bottom bolt case with six (6)
#10-24 X 1/2" PFHMS.
D. Thread set screw into yoke pins (Insert with
hex socket end inside pin). Thread #8-32
x 2" PHPMS screws into slotted end of
yoke pins until seated to hex head set
screw. (Detail 1 - Figure 14)
E. Install two
(2) yoke pin
assemblies
into arm
and bracket
assemblies.
10
Install Device
A. Mount trim when
required. (Follow
instructions packed
with trim.)
B. Seat device in place.
Connect device to
arm and bracket
assemblies using
temporary screws to
position yoke pins
in latch head. Install
e-ring into yoke pin
grooves. (Detail 1 - Figure 17)
C. Fasten device latch head using two (2)
1/4-20 PRHMS or 3/8" (10) dia. SNB.
(Figure 16)
D. Remove temporary screws.
NOTE: Be certain to re-tighten yoke
pins after removal of temporary screws.
E. Center end of device on horizontal
reference line of door. Using end clamp as
a template, locate end clamp mounting
holes.
F. Prepare end clamp holes and mount end
clamp using two (2) 1/4-20 PRHMS or
3/8" (10) SNB. (Figure 16)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2012, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
A
B
B
Detail 1
C
Device Screws
(Bolt to door reinforcement,
sex nuts, or trim studs)
7
Detail 1
1/4"
Yoke Pin
(6.4)
Set Screw
#8-32 PHPMS
Temporary Screw
Figure 14
E
Figure 15
C L
Device
Horizontal Ref.
Figure 16
Centerline
Detail 1
E-Ring
Yoke
Pin
Figure 17
E-ring Groove
C
F
End
Clamp
1-1/4
(32)
1/2
(13)
FM171 01/19
Advertisement
Table of Contents
