CompuSTAR RF-2WT10R-SS Quick Start Card page 2

START ERROR CODES
PARKING LIGHT FLASHES
3 then 1 1: Motor running
3 then 2 2: Key in ignition on position
3 then 3 3: Door open (manual transmission only)
3 then 4 4: Trunk open
3 then 5 5: Foot brake on
3 then 6 6: Hood open
3 then 7 7: Reservation off (manual transmission only)
3 then 8 8: Tach or voltage sensing failure
3 then 9 9: FT-DAS sensor shutdown
3 then 10 10: System is in Valet Mode
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
Questions/comments? Contact us at 888-820-3690 from 8 AM
to 5 PM PST. Also please visit www.compustar.com for a complete
user's manual.
2WLCD-SepLU_QuickCard line.indd 2
QUICK START CARD
REMOTE START ERROR
START ERROR CODES
LCD
FEATURE
READOUT
Enter and Hold Unlock and Trunk Buttons
Exit Menu for 2.5 Seconds
Up Tap the Trunk Button
Down Tap the Start Button
Adjusts Adjusts
Time
Hour Minute
Remote Adjusts Adjusts
Start Time Hour Minute
Alarm Clock Adjusts Adjusts
Time Hour Minute
Alarm Clock On of Off
RPS On or Off
Vibrate On or Off
Temperature Fº / Cº On or Off
Register online at www.compustar.com within 10 days of purchase to
activate your new remote's warranty.
RF-2WT10R-SS
FUNCTION/DESCRIPTION
Put remote in programming mode.
Exits after 20 seconds of inactivity.
Moves down the menu
Moves back up the menu
Sets the current time on your remote.
(Not available on all LCD remotes)
Sets the time start. Please check with
your installer for additional info.
Sets the time in which you would like
the remote's alarm clock to alert you.
This feature turns the alarm clock
on or off.
Turns your RPS Touch paging feature
on or off.
Turns the silent mode on or off.
Switches between Fº and Cº.
2013/6/6 10:13:06