Volkswagen Passat 1995 Official Factory Repair Manual page 145

Transmission, checking
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.37.2
Main pressure, checking
- Before checking the main pressure, check the
Diagnostic Trouble Code (DTC) Memory and, if
necessary, repair electrical malfunctions.
- Check DTC Memory
Repair Group 01, On Board Diagnostic
Pressure gauge connection for automatic
transmission 096 (arrow)
- Remove main pressure drilling plug.
Always replace main pressure drilling plug
- Connect pressure gauge VAG 1702 and tighten
knurled screw.
- Bleed pressure gauge VAG 1702 line by loosening
knurled screw with engine running.
CAUTION!
Tighten the knurled screw again after bleeding.
- Bring automatic transmission fluid (ATF)
temperature to 60 C (140 F); to do this connect
VAG 1551 Scan Tool (ST) and read temperature in
measured value block.
Page 7 of 8
37-32
12/6/2004