Introduction; For The Home Owner; For The Installing Dealer/Contractor - Briggs & Stratton 71013 Installation And Operator's Manual

INTRODUCTION

Thank you for your purchase of this Briggs & Stratton
Power Management System.This product is intended for
use with Briggs & Stratton Automatic Transfer Switches and
Home Standby Generators ONLY.This is an optional
automated system that will control the distribution of
power from a home standby system (generator) to selected
household loads.
Briggs and Stratton (B&S) has made every effort to provide
for a safe, streamlined and cost-effective installation. As
each installation is unique, it is impossible to know of and
advise of all conceivable procedures and methods by which
installation might be achieved.We do not know all possible
hazards and/or the results of each method or procedure.
For these reasons,
Only licensed electrical contractors
should install power management
systems. Installations must strictly comply
with all applicable federal, state and local
codes, standards and regulations.
Your B&S power management system is supplied with this
combined "Installation and Operator's Manual".This is an
important document and should be retained by the owner
after the installation has been completed.
Every effort has been expended to make sure that the
information in this manual is both accurate and current.
However, the manufacturer reserves the right to change,
alter or otherwise improve the system at any time without
prior notice.
INTRODUCTION

For the Home Owner

To help you make informed choices and communicate
effectively with your installation contractor(s),
Owner Orientation Section of this manual
BEFORE contracting or starting
your power management system installation.
To arrange for proper installation, contact the store at
which you purchased your B&S power management system,
your dealer, or your utility power provider.
warranty is VOID unless the system is installed
by a licensed electrical professional.

For the Installing Dealer/Contractor

Check federal, state and local codes for questions on
installation.
If you need more information about the power
management system, call 1-800-743-4115, between
8:00 AM and 5:00 PM CT.
4
Read and understand the
The power management system