Assembly Of The Ato - Nokia 7600 Disassembly Instructions Manual

NMM-3
5 - Disassembly Instructions
Assembly of ATO Module
Protection Pad (not supplied)
Page 5-16
Company Confidential
Copyright  2003 Nokia Corporation.
Company Confidential
CCS Technical Documentation
5. Place a Navi key assembly onto the
5
UI PWB, ensuring the alignment pips
on the bottom of the Navi key assem-
bly are located into the holes in the
UI PWB.
Note: Ensure the Class I surfaces of
the Navi key are kept clean and
undamaged. These must be checked
before assembly.
6. Place a lightguide assembly onto
6
the UI module assembly, sliding the
top right lightguide tab under the
LCD frame first, then clipping the
right then left clips to the engine
shield and finally placing the top left
lightguide alignment hole over the
top left engine shield alignment pin.
Note: Ensure the lightguide is not
distorted and the side clips are fully
assembled and not cracked. Also
ensure that all LED's are within the
recesses in the lightguide provided for
them.
1. Assemble the engine PWB onto
the UI module (making sure the mod-
ule is first placed LCD down). Ensure
the engine is located onto the engine
shield alignment pins.
Note: Ensure the board to board con-
nector and camera assembly are
avoided by only holding the PWB
module in the designated areas indi-
cated.
Issue 1 (11/2003)