Mounting And Powering The Campervan Device In Your Vehicle; Turning The Device On Or Off - Garmin CamperVan Owner's Manual

Mounting and powering the CamperVan device in your vehicle

This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage
caused by battery exposure to extreme heat, store the device out of direct sunlight.
Before you use your device on battery power, you should charge it.
1 Plug the vehicle power cable
2 Press the mount onto the suction cup
3 Press the suction cup to the windscreen, and flip the lever
4 Fit the tab on the top of the mount into the slot on the back of the device.
5 Press the bottom of the mount into the device until it clicks.
6 Plug the other end of the vehicle power cable into a power outlet in your vehicle.

Turning the device on or off

• To turn the device on, press the power key
• To put the device in power saving mode, press the power key while the device is on.
While in power saving mode, the screen is off and the device uses very little power, but it can wake instantly
for use.
TIP: you can charge your device faster by putting it in power saving mode while charging the battery.
• To turn off the device completely, hold the power key until a prompt appears on the screen, then select Off.
The prompt appears after five seconds. If you release the power key before the prompt appears, the device
enters power saving mode.
2
WARNING
into the USB port on the device.
until it snaps into place.
or connect the device to power.
back toward the windscreen.
Getting started