Nokia 6610 Troubleshooting Instructions page 35

CCS Technical Documentation
$FFHVVRU\ )DXOW
Start
Is accessory detected
No
when connected to
system connector?
Yes
End
,VVXH  
Company confidential
)LJXUH  $FFHVVRU\ WURXEOHVKRRWLQJ
Check system
connector X101
No
(solder ings, contact
plates). Is it OK?
Yes
Measure ACI-line
(pin3). No
Is it ~0.83...1.13V?
Yes
Measure VOUT
No
voltage (pin4).
Is it ~2.8V?
Yes
Retest
Measure ACI-line
(pin3). No
Is it ~0V?
Yes
Measure VOUT
No
voltage (pin4).
Is it ~0V?
Yes
Retest
1RNLD &RUSRUDWLRQ
Troubleshooting Instructions
Repair solderings or check contact
plates if dirty. Retest.
ACI-Accessory
Check ACI- line (L106,R103,R102,R109,C103).
If not OK, change defect part and retest.
Check VOUT-line (N100, L107, R103, C101,
C102, C112).
If not OK, change defect part and retest.
Non-ACI Accessory
Check ACI- line (L106,R103,R102,R109,C103).
If not OK, change defect part and retest.
Check that regulator N100 enable-pin is
LOW-state.
If not OK, check ACI-line again
NHL-4/4U
3DJH