Assembly - Briggs & Stratton PRO4000 Owner's Manual

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115.
Remove Generator From Carton
1. Set carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
2. Carefully open top flaps of shipping carton.
3. Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
4. Remove all packing material, carton fillers, etc.
5. Remove generator from shipping carton.
Carton Contents
Check all contents against those listed below:
• Main unit
• Engine oil
• Owner's manual
Figure 1 — Install Wheel Kit
Hex Nut
Flat Washers
Cap Screw
Handle
BSPP Generator
Nylon Washers
Hex Nut
Use
existing
hardware
Support Leg
Vibration Mounts
Cap Screw
• Engine manual
• Battery charge cables
• Locking 120/240V, 20A plug
• Locking 120V, 30A plug
• Wheel kit
If any parts are missing or damaged, call the generator
helpline at 1-800-743-4115.
INSTALL WHEEL KIT
The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a 1/2" or 13mm socket wrench and a 1/2" or
13mm open end wrench and a 7/16" socket wrench and
7/16" open end wrench and a needle-nose pliers to install
this kit.
NOTE: Adjustable wrenches may be substituted for open
end wrenches.
Refer to Figure 1 and install the wheel kit as follows:
1. Place the bottom of the generator frame on a flat, even
surface.Temporarily place unit on blocks to ease assembly.
2. Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 1.
Axle
Handle Pin
Cap Screw
Hex Nut
6
Wheel
Flat Washer
E-Ring