Additional Safety Rules - Panasonic EY47A1 Operating Instructions Manual

11. To reduce risk of electric shock,
EN
unplug charger from outlet before
attempting any maintenance or
cleaning.
12. Make sure cord is located so that it
will not be stepped on, tripped over,
or otherwise subjected to damage or
stress.
13. Do not store battery pack in locations
where the temperature may reach or
exceed 50°C (such as metal tool
shed, or a car in the summer), which
can lead to deterioration of the
storage battery.
14. Do not incinerate the battery pack. It
can be explode in a fire.
15. The charger is designed to operate
on standard household electrical
power only. Charge only on the
voltage indicated on the nameplate.
Do not attempt to use it on any other
voltage !
16. Charge the battery pack in a well
ventilated place, do not cover the
charger and battery pack with a cloth,
etc., while charging.
17. Do not short the battery pack. A
battery short can cause a large
current flow, over heating and burns.
18. NOTE: If the supply cord of this
appliance is damaged, it must only
be replaced by a repair shop
appointed by the manufacturer,
because special purpose tools are
required.
19. This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
20. Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
III. ADDITIONAL
SAFETY RULES
1) Wear ear protectors.
Exposure to noise can cause
hearing loss.
2) Keep hands away from cutting area
and blade. Keep your insulated
gripping surfaces. If both hands are
holding the tool, they cannot be cut
by the blade.
3) Never hold piece being cut in your
hands or across your leg. It is
important to support the work
properly to minimize body exposure
or loss of control.
4) Be aware that this tool is always in
an operating condition, since it does
not have to be plugged into an
electrical outlet.
5) Always use safety goggles or
glasses with side shields. Ordinary
eye or sun glasses are NOT safety
glasses.
6) When this tool is used for
woodworking in confined areas
(e.g. indoors), wear dust mask.
7) Avoid cutting nails. Inspect
workpiece for any nails and remove
them before operation.
8) Do not cut oversized workpiece.
9) Check for the proper clearance
beyond the workpiece before
cutting so that the blade will not
strike the floor, workbench, etc.
10) Hold the tool firmly.
11) Make sure the blade is not
contacting the workpiece before the
switch is turned on.
12) Keep hands away from moving
parts.
13) Do not touch the blade or
workpiece immediately after
operation; they may be extremely
hot and could burn your skin.
14) Never swing tool.
15) Do not use blades which are
deformed or cracked.
– 12 –