Adjust Staple Clinch; Control The Clinch - Josef Kihlberg c.561PN Operating Instructions Manual

Josef Kihlberg c.561PN
KUDA PACKAGING

6.3 ADJUST STAPLE CLINCH

Be sure that the tool is not pointing at
yourself or anyone else when connec-
ting it to the compressed air line.
It is possible to adjust how tightly the staples are
closing.
– With a small screwdriver turn the adjusting nut
behind the slot (Fig. 6/1). Turn clockwise to close
the clinch (6/A). Turn the adjusting nut anticlockwise
to open up the clinch (6/B).

6.4 CONTROL THE CLINCH

Correct
Correct
Correct
1 Good clinch.
2 Leg length of the staple too long or over bended.
3 Leg length of staple too short or not enough
To long staple
To long staple
bended.
To long staple
If necessary adjust staple clinch, see chapter 6.3.
To short
Always use Josef Kihlberg original
To short
To short
staples: JK561-15 or JK561-18.
Fel
Fel
Fel
SERVIS A NAHRADNÍ DÍLY
8
www.kuda-packaging.com
Fig. 6
1
2
3
Fig. 7
+420 607 237 237
info@kuda-packaging.com
1
A
B
servis@josef-kihlberg.eu
06.14