Installation - Cerwin-Vega pro mobile Series Owner's Manual

Installation

Installing the Speakers
Your new Cerwin-Vega Mobile Pro Full range Coax Horn speakers were designed with the flexibility
to be installed in multiple Locations. However, to ensure the best performance possible, it is important
to isolate the front sound waves of the speaker from its rear sound waves. This is done by securely
mounting the speaker to a flat surface known as a baffle. Make sure to seal the speaker to ensure
there are no air leaks around its frame. Screws are NOT included, as these are installed totally
into custom installs, and we know how you guys (gals) are!
Selecting a Location
Since these are "Pro Drivers" we know the likelihood of mounting in stock locations is pretty non-
existent. This means basic audio concepts should be thought of when installing. Solid mounting, no
airleaks, etc. Venting (or porting) is not necessary. Line the walls of the enclosures with deadliner
if possible.
We HIGHLY recommend that for the BEST sound you put a sound deadening mat on the door "skin",
fairing or bag, The more "damped" your vehicle/bike is.... the better it will ultimately sound!!!
Remember that the Midrange driver is 4W and the Tweeter is 8W. These drivers were especially designed
for Motorcycles but can be used in cars, trucks, boats and UTVs as the cones are UV
and water resistant. They are light weight and extremely efficient
SYSTEM DESIGN - PASSIVE
TYPICAL SYSTEM USING
INCLUDED PASSIVE CROSSOVERS
Cerwin-Vega Mobile Pro Full range Coax Horn
speakers comes with a special 12dB per octave
crossover. It is HIGHLY recommended that this
be used at ALL times - UNLESS you are using
an active crosssoverset at above 7kHz. This
system, shown is run off the Front channels of
this 4 channel amplifier are driving the PH654
Pro Audio CoAx Horn drivers. Rear channel
are driving the PH694 Pro Audio CoAx Horn drivers
(ONLY RIGHT CHANNEL SHOWN)
** SPECIAL NOTE**
Tweeter connected "Out-of-Phase" to be acoustically "In-Phase"
Front channels
4 Channel
Amplifier
Rear channels
PHCOAX tweeter
12dB per octave
High-Pass filter
(included)
+
"OPTIONAL"
TWEETER ATTENUATION
+
4 Ohm resistor
INCLUDED
5