Advertisement
English
3. FUNCTIONS
Main power switch (4):
This switch is located on the amplifier panel.
To switch the subwoofer amplifier to ON or OFF mode.
Make sure it is turned OFF during installation.
Turn OFF the subwoofer when it will not be used for a
longer period of time. When main power is OFF, the
display indicates nothing. When main power is on in
standby mode the display indicates POWER OFF.
Standby switch (8):
This switch is located on the display panel. Press to
turn ON or OFF (standby mode) if the main power
switch is set to ON.
The amplifier enters automatically the standby mode if
no signal has been detected for about 30 minutes. It
automatically enters ON mode when signal is detected
again.
The display panel indicates POWER OFF when in
standby mode.
Power indicator: (Blue on front)
The blue indicator shows the operation status. Blue
light on - the subwoofer is on. Blue light off - the
subwoofer is either OFF or in Standby mode.
Remote control:
With the enclosed remote control you can adjust
volume and phase, control Standby ON/OFF and adjust
the display light dimmer (3 steps). Here you also find
four factory presets. User preset can be changed and
stored in the memory.
ASP functions
All ASP functions are controlled by the display panel
located on top of the subwoofer.
Choose the function to be adjusted with the MODE
button. Adjustments are made using the + or - buttons.
(Volume and phase can also be adjusted from the
remoter control.)
For more information see the separate ASP manual.
Following can be adjusted by the ASP
module:
Volume
Crossover
Slope
Subsonic
Bass Equalizer
Phase
Note: If the connection is made by LFE-
input, the ASP function is not available.
8
Advertisement
