Sealey MAC03 Quick Start Manual

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Keep away
instructions from rain
1. safety
warninG! Read instructions before use. Suitable for 12V operation only.
‰
warninG! This compressor is capable of producing a high pressure. do not inflate any item beyond its maximum capacity.
‰
do not leave the unit unattended while in operation.
8
Check capacity and maximum pressure of inflatable before commencing inflation.
9
monitor the pressure gauge while in operation.
9
The gauge should be used as an indication of pressure only. We recommend the use of a dial pressure gauge for definitive reading.
9
locate compressor on an appropriate surface for use.
9
The 12V auxiliary plug must not be substituted with any other type of plug or electrical supply.
9
do not direct inflation hose connector head at yourself, others or animals.
8
do not carry by the hose, or pull the hose sharply from a valve.
8
do not pull the power cable from the vehicle accessory socket.
8
do not get the compressor wet or use in the rain.
8
do not use the compressor for a task it was not designed to perform.
8
do not operate the compressor when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
do not operate the compressor if any parts are missing as this may cause failure or possible personal injury.
8
do not open the unit.
8
Keep children and non essential persons away from the inflation area.
9
Keep the compressor clean and in good condition.
9
Replace or repair damaged parts. Use recommended parts only. non authorised parts may be dangerous and will invalidate the
9
warranty.
2. introduction
mini air compressor with delivery of 45ltr/min. Twin cylinder design improves air delivery compared to a single cylinder unit. Integral storage for
air output hose. Features work light for use in low light areas. Pressure gauge reads up to 6bar/80psi. Suitable for inflating tyres on cars, vans
and 4x4s. Supplied with 3mtr power cord with plug for use in vehicle accessory socket, 650mm high pressure hose with screw-on connector
and accessory kit including ball needle and adaptors for inflatables.
3. specification
model no .................................................................... MAC03
Hose length ............................................................... 650mm
Power Cord length ........................................................... 3m
weight ......................................................................
operating Voltage ............................................................12V
Typical Inflation Time ............. 0-30psi in 95sec. (175/70/R13)
max. Current ....................................................................20A
4. operation
warninG! Ensure you have read and understood the safety instructions. Place the compressor on a sound, flat surface ensuring that
‰
the inflation air hose can reach the tyre valve.
4.1. Remove the valve cap and screw the air hose onto the tyre valve.
important: Inflation will only be effective if the connector head is fully fitted and secured onto the valve.
4.2. Check the pressure gauge to determine the amount of pressure already in the tyre. we recommend the use of a dial pressure gauge for
a definitive reading.
4.3. Check that the compressor on/off switch is in the off position before connecting to the power supply.
Insert the plug into the vehicle's accessory socket. IMPORTANT: make sure that the maximum current draw is within the
capacity of the accessory socket.
Start the vehicle engine and switch the compressor on. View the pressure gauge to determine when the correct pressure has been
achieved. Switch the compressor off to stop the supply of air.
note: As the delivery pressure increases, the pump delivery volume will decrease.
© Jack Sealey limited
tyre inflator/mini air compressor
twin cylinder 12V
mac03
model no:
2.73kg
Original Language Version mAC03 Issue 2 (H) 08/03/19