Skil 3610 Operating And Safety Instructions Manual page 36

Vea la figura 10
When positioning rip fence and handle 3 (see fig.
WARNING
Artículo Descripción
10) for maximum rip cutting , make sure side of
Ensamblaje de la sierra de mesa
1.
fence housing (a) is even with the side edge of the table Do not
Calibre de ingletes
2.
make rip cuts or dado cuts beyond this position because the fence
Tope guía de corte al hilo y mango
3.
can not be properly locked.
Mango de la rueda de elevación de la hoja
4.
Ensamblaje de la protección de la hoja
5.
Llaves de tuerca para la hoja
6.
Dispositivo antirretroceso
7.
It consists of 2 key elements: Device Anticontragolpe Guard and
Accesorio de inserción de la mesa
8.
Blade Guard. All these are part of a modular system that needs
Barra de empuje
9.
no tools to assemble and dismount. This protection system
Placas superiores largas
10.
should always be in place and working properly for cuts.
Placas superiores cortas
11.
Placas largas de soporte
12.
Placas cortas de soporte
13.
For your own safety, turn switch "OFF" and
WARNING
Patas
14.
remove plug from power source before removing
Pies de goma
15.
insert. This item consists of two parts (each with different widths).
To avoid injury when mounting the insert of the table follow the
It consists of 2 key elements: Device Anticontragolpe Guard and
Blade Guard. All these are part of a modular system that needs
no tools to assemble and dismount. This protection system
should always be in place and working properly for cuts.
WARNING
insert. This item consists of two parts (each with different widths).
To avoid injury when mounting the insert of the table follow the
instructions below.
To remove the insert:
A. Lower the blade below the table surface.
B. Place the set of protective guard in position 45 º .
C. Remove the screws that hold the insert the table.
D. Remove the sides of the insert notches.
WARNING
3610
WARNING
See figure 10
Cantidad
1
1
1
1
1
2
1
1
1
2
2
2
36.
2
4
4
For your own safety, turn switch "OFF" and
remove plug from power source before removing