Cleaning And Care; Auto Clean™ System; Storing Your Iron - Black+Decker D3300 Use And Care Manual

CLEANING AND CARE

This product contains no user serviceable parts. Refer to service qualified
service personnel.
CLEANING OUTSIDE SURFACES
1. Make sure the iron is unplugged and has completely cooled.
2. Wipe the soleplate and outer surface with soft, damp cloth. Water
and small amounts of gentle household soaps, such as dishwashing
liquid, can be used. Never use heavy-duty cleaners, vinegar or
abrasive scouring pads that may scratch or discolor the iron.
3. After the iron has been thoroughly dried, turn the iron back on and
lightly steam over an old cloth. This will help remove any reside left in
the vents.
4. When finished cleaning, turn iron off and allow time to cool before
storing.
AUTO CLEAN™ SYSTEM
For optimal results over time, it is recommended that you clean your iron
about once a month to keep the steam vents free of build up.
1. Fill the water tank well below the MAX fill line. Plug in the iron.
2. Select the cotton/linen setting on the Temperature dial and stand the
iron on its heel while it preheats.
3. Once the iron has reached the desired temperature; turn it off and
then unplug it from the outlet.
4. Hold iron over a sink with the soleplate facing down.
5. Press and hold the AUTO CLEAN™ button
and steam will come out of the vents.
6. Continue to press the button until all of the water has emptied. If
necessary, move the iron side-to-side and front-to-back to aid the
process.
7. When finished, release the AUTO CLEAN™ button and place the iron
on its heel rest.
8. Plug the iron back in and allow it to heat for about 2 minutes to dry
out any remaining water.

STORING YOUR IRON

1. Once the iron is turned off and unplugged from the outlet, allow it
to cool.
2. Check that the variable steam dial is set to dry.
3. Wrap the cord loosely around the iron.
4. Store vertically on its heel to prevent water leaking from the soleplate.
6
. Be careful, as hot water