LEGRAND 7 521 84 Quick Start Manual

Connected switch
7 521 84 - 7 522 84 - 7 523 84
This pack is a connected accessory which requires you to buy and install the Valena Life
with Netatmo connected starter pack first.
Pack contents
Connected switch Site protection
(with dimmer option)
+ bleeder
Characteristics
In default mode (on/off ), this switch works with the following types of bulb :
+ 45°C
+ 5°C
100-240 VAC 2 x 2,5 mm2
50/60 Hz
Max. 300 W
240 VAC
Min. 7 W
Max. 150 W
100 VAC
Min. 7 W
(*) or 10 bulbs max. For comfortable lighting, we recommend using bulbs of the same type and make.
( ** ) Using only transformers intended for operation with electronic switches. Take account of tranformer
losses for power calculations. Transformers should be charged to over 60% of their rated power..
In dimmer option operating mode (wich can be activated via the App), this
switch functions only with dimmable bulbs (identifiable by the logo on
packaging).
0 401 49
Finishing plate
- 5° C
( **
LED
Dimmable
(*)60 W 60 W 300 VA
5 W 9 W 10 VA
(*)30 W 30 W 150 VA
5 W 9 W 10 VA
Before you start: wiring precautions
If you plan to install two-way light switches or switched power outlets,
read the following precautions:
To control a light with two or more switches,
only use the products:
100/240 V~
50/60 Hz
11 mA
Connected switch (with dimmer option)
+ 55° C
+ bleeder
Do not use: two connected switches (with dimmer option) to control
the same lighting point.
)
Tip if replacing a two-
way switch:
old flush-mounted
switch replaced by the
wireless switch.
300 VA
35 VA
150 VA
35 VA
Use a connector to
connect all 3 wires
together (travellers 1 and
2 and lamp return wire).
AND
x 1
Wireless switches for all control points
(not included in this pack)
Wire which goes back
to the light
Traveller 1
Traveller 2
2
x 1
or several