Auto Address Setting - Panasonic S-80MW1E5 Service Manual & Test Run Service Manual

2.Auto address setting

7-2. Auto address setting
<Procedure of CZ-RTC5>
Keep pressing the
1
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
Press the or
2
menu.
If you wish to see the next screen instantly, press
the or button.
Select "9. Auto address" on the LCD display and
press the button.
Maintenance func
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Sel. Page [
3 The "Auto address" screen appears on the LCD
display.
Change the "Code no." to "A1" by pressing the
or button.
Auto address
Code no.
A1
Sel. Next
Select the "O/D unit no." by pressing the
4
button.
Select one of the "O/D unit no." for automatic
address by pressing the
Then press the
Approximately about 10 minutes are required.
When automatic address setting is completed, the
units return to normal stopped status.
, and
button to see each
20:30 (THU)
] Confirm
20:30 (THU)
O/D unit no.
1
or
or button.
button.
[ ]
START
Checking indoor unit addresses
1 Keep pressing the
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
Sel.
Press the
2
menu.
If you wish to see the next screen instantly, press
the or
Select "7. Simple settings" on the LCD display and
press the
Maintenance func
5. Sensor info.
6. Servicing check
7. Simple settings
8. Detailed settings
Sel.
The "Simple settings" screen appears on the LCD
display.
Select the "Unit no." by pressing the
button for changes.
Simple settings
Unit no.
3-1
Sel.
The indoor unit fan operates only at the selected
indoor unit.
7 - 3
VRF SYSTEMS Indoor Unit VRF SYSTEMS Indoor Unit Air-to-Water Indoor Unit Air-to-Water Indoor Unit
20:30 (THU)
CZ-RTC5
, and
20:30 (THU)
Page [ ] Confirm
or button to see each
button.
button.
20:30 (THU)
Page [ ] Confirm
20:30 (THU)
Code no. Set data
01 0001
Next
7 7
or