Test Run For Water Circuit - Panasonic S-80MW1E5 Service Manual & Test Run Service Manual

3. Test Run for Water Circuit

7-3. Test Run for Water Circuit
<Procedure of CZ-RTC5>
* You cannot perform the test run of refrigerant circuit if test
run for water circuit has not been completed.
* First, pour water into the water circuit.
1 Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the LCD
display.
0. ECONAVI info.
1. Outdoor unit error data
2. Service contact
3. RC. setting mode
Sel.
2
Press the
you wish to see the next screen instantly, press the
or button.
Select "13. Air-to-Water unit" on the LCD display and
press the
10. Set elec.consumption
11. Set touch key
12. Check touch key
13. Air-to-Water unit
Sel.
• Air purge
Press the
press the
Select "Air purge" on the LCD display and press the
Air-to-Water unit
Air purge
Pump speed setup
Cancel int.heater alarm
Air-to-Water settings
Sel. [ ]
7 7
"Air purge failure" message is caused by abnormalities of following.
Reference of Alarm code : P09 (Abnormal water flow)
Reference of Alarm code : P12 (Abnormal Water Pump speed)
, and
Maintenance func 20:30 (THU)
Page [ ] Confirm
or button to see each menu. If
button.
Maintenance func 20:30 (THU)
Page [ ] Confirm
or button to see each menu. If you wish to see the next screen instantly,
or button.
After 30 minutes have passed, the following process becomes
automatically effective. (Pump will start operation.)
Air-to-Water unit
20:30 (THU)
Set
Air-to-Water unit
success
Air-to-Water unit
buttons
[
button.
20:30 (THU)
Start air purge?
[ ] Start
Pump will start operation for Air purge.
20:30 (THU)
After 10 minutes have passed, the air
purge is ended (pump stops).
Purging air
It is possible to press
* Do not proceed to the Pump speed setup
until the air purge is completed.
failure
20:30 (THU)
Air purge failure
[ ] Confirm
7 - 4
Air-to-Water Indoor Unit Air-to-Water Indoor Unit
20:30 (THU)
]
START
CZ-RTC5
button to cancel.