Atlas M-1A Brochure & Specs

Atlas Sound Infrared Repeater System & Devices
Micro Infrared Repeaters & Flashers
M-1A Series Atlas Sound IR repeaters allow the operation of virtually any IR-controlled A/V component from multiple
room locations. The M-1A repeater will receive the IR signal and rebroadcast it to the small
on the front of each A/V component. The
These micro repeaters feature an attractive, flush, white lens that blends with any white surface. Their high sensitivity
enables use within a 40 foot range with fast reaction time and minimal interference. Repeaters are available installed
on a white decorator-style subplate (cover plate not included) or separately for flush-mounting in a ceiling, wall,
cabinet or speaker grille.
F-1 Series Small F-1 flasher LEDs are shipped with an adhesive backing and
all IR-controlled A/V components. Up to six flasher units may be connected to a single
connector blocks or any standard adapter (by others).
M-1CB4B
Note: some high-end A/V components are equipped to accept hard-wired IR signals. In this case, F-1 flashers would not be necessary.
Model Description
M-1A IR Repeater
M-1AJW IR Repeater
F-1 Flasher
* Order Sound decorator-style cover plate separately.
** Order Model M-1A separately.
Stand-Alone IR Repeater System
M-1CB4B For installation flexibility, the
that provides connections for an
figuration allows IR operation of up to four A/V components from up to four room locations. The
mini jacks for power supply Model
M-1A repeaters (rooms) in parallel fashion and a data jack for connecting a mini-pin IR source or another M-1CB4B.
The unit's amplified circuit design supplies clear, strong IR data to source components.
This stand-alone IR repeater system requires: one
every four A/V components, a PS-M12
which require control of more than four components or transmission from more than four rooms, multiple
blocks may be used.
Note: each M-1A repeater can control a maximum of six F-1 flashers.
A compact UL-listed 12VDC, 200 mA power supply with a 6' cord. The required input voltage is 120V. Supply
PS-M12
includes a ⁄ " mini-plug for direct connection to the
1
8
use with up to two switched WhisperTouch
Remote
Range:
Maximum 40'
at 30˚off axis.
800.876.3333
F-1 forwards the signal to the source component's IR receiver.
Current Draw Style
12 mA Flush Mount
12 mA Wall Mount, Supplied on Decorator Subplate*
.05 mA Surface Mount
M-1CB4B amplified connector block is offered as a plug-in interface device
M-1A Series repeater, four F-1 flashers, and power supply Model PS-M12. This con-
PS-M12 and up to four F-1 flashers; it also provides terminals for wiring up to four
M-1A repeater in each remote room location, one
power supply, and one F-1
M-1CB4B connector block (powers up to four
volume controls.
®
F-1 flasher LED positioned
⁄ " phone plugs for connection to
1
8
M-1A repeater using two
Color
White Lens
White Lens,
White Subplate
Black Lens, Black Cord
M-1CB4B
flasher for each A/V component. For installations
F-1
F-1
*(Shown with cover plate,
offers ⁄ "
1
8
M-1CB4B for
M-1CB4B
flashers) or for
M-1AJW* M-1A
Sold separately.)
M-1CB4B
PS-M12
57