Theben Timeguard SupplyMaster FST24 Installation & Operating Instructions Manual page 8

• Once the desired day grouping is selected,
press Prg button once to set and move
onto programming the ON/OFF times.
• The display will show Prog 1, with dashes
for the hours and minutes;
Note: the example shown is for
5 day + 2 day programming.
• Use Adv/Ovr or Boost button to set the hour for the first ON period.
• Press the Prg button once to set and move you to the minutes.
• Use Adv/Ovr or Boost button to set the minutes for the first
ON period.
• Press the Prg button once to set and move you to the
Programme 1 OFF time.
• Use Adv/Ovr or Boost button to set the hour for the first OFF period.
• Press the Prg button once to set and move you to the minutes.
• Use Adv/Ovr or Boost button to set the minutes for the first
OFF period.
• Press the Prg button to scroll through Programme 2 ON,
7
Programme 2 OFF, Programme 3 ON, Programme 3 OFF,
Programme 4 ON and programme 4 OFF, adding in times as required.
Note: If further times are not required, just leave the dashes in place
and scroll past the rest of the programs using the Prg button.
• After Programme 4 has been entered, then next day grouping
will follow e.g. In this example the day grouping will change
to 2 day – Sa Su Programme 1 ON.
• Programme the ON/OFF times as before.
• After the last OFF time for programme 4 has been set, press the
Prg button once to exit the programme mode.
Note: At any stage in programming, if the Prg button is pressed and
held for 3 seconds, the timer will return to normal operating mode.
• The display will now show the correct time
and day as per this example;