Table of Contents
Advertisement
Operation by built-in battery
The projector can be also operated on built-in
battery for portability.
Charge the projector
Charge the projector for 1.5 hours before first
use.
Charge the projector when the low battery icon
appears in the projection screen.
•
To charge the projector, connect the
projector to an external power supply as
described in the section of "Operation by
external power".
•
When charging, the LED on the projector
turns red. When fully charged, the red LED
turns off.
•
When powered on, the external power
will be used first to run the projector and
unused power will charge the battery.
•
For faster charging, charge while the
projector is powered off.
Notice
The capacity of the built-in battery
diminishes with time. If the projector
functions only with external power
supply, the built-in battery is defective.
Contact an authorised service centre to
replace the built-in battery.
Prepare the remote control
CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1
Open the battery compartment.
2
Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
8
3
Close the battery compartment.
•
When using the remote control with infrared
signals, point the remote control at the IR
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.
Power on
1
Press
to turn on the projector. The LED
on the projector turns from red to white.
•
To turn off the projector, press
then press it again when the power-off
confirmation message pops up.
The LED on the projector turns from white
to red.
•
The distance between the projector and
the screen determines the actual size of the
image.
First time setup
When you turn on the projector for the first time
or the projector is reset to the factory default
settings, you are prompted to make the Android
TV setup.
After setup, the projector will sign in to your
Google account and connect to the same WiFi
network as your phone.
What you need
•
A WiFi internet connection
•
A Google account
Step 1: Pair the remote control
with the projector
In the remote control pairing interface, you
are prompted to pair the remote control with
the projector through Bluetooth. Pairing can
enable the remote control to work in Android
TV mode.
and
Philips · PicoPix Micro 2
TV
Hide quick links:
Advertisement
Table of Contents
