Asus PCI/E-P54NP4 User Manual page 57

You must install the Windows
disk drives. The Serial ATA RAID feature (RAID 0/RAID 1/RAID 5/RAID 10) is
available only if you are using Windows
Connect the right-angle side
of SATA signal cable to SATA
device. Or you may connect the
right-angle side of SATA cable to
the onboard SATA port to avoid
mechanical conflict with huge
graphics cards.
4. USB connectors (10-1 pin USB 78, USB 910, USB 1112)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
RAMPAGE FORMULA
RAMPAGE FORMULA USB 2.0 connectors
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
You can connect the USB cable to ASUS �-Connector (USB, blue) first, and
then install the Q-Connector (USB) to the USB connector onboard.
ROG Rampage Formula
XP Service Pack 1 before using Serial ATA hard
®
XP or later version.
®
right angle side
USB1112
USB910 USB78
2-31