superbrightleds DS-DMX36 User Manual

Important: Read all instructions prior to installation.
3-Channel DMX/RDM Decoder
System Settings
1. Hold M and ◄ at the same time for 2 seconds. Press M to cycle between settings.
2. To set "output PWM frequency" press ◄ or ► button to switch between 500 Hz ("F-L")
or 2 kHz ("F-H").
Note: Higher PWM frequency will cause lower output current and higher noise, but is
more suitable for cameras (less flicker for video).
3. To set "output brightness curve" press ◄ or ► button to switch between linear curve
("C-L") or logarithmic curve ("C-E").
4. To set "automatic blank screen" press ◄ or ► button to switch between enable
("bon") or disable ("boF") automatic blank screen.
5. Hold M for 2 seconds to exit settings. If no input is detected for 10 seconds, the
decoder will automatically exit settings.
DMX Mode
• If there is a DMX signal input, decoder will enter DMX mode automatically. To manually enter DMX mode,
press M button. Display will show 001-999.
• Press ◄ or ► button to switch between DMX decode start address (001-999). Hold ◄ or ► button to
change the address faster.
• Each DMX decoder occupies four DMX addresses. The default start address is 1. See the table below for
the corresponding relationships.
DMX Console DMX Decoder Output
CH1 0–255 CH1 PWM 0–100% (LED R)
CH2 0–255 CH2 PWM 0–100% (LED G)
CH3 0–255 CH3 PWM 0–100% (LED B)
DS-DMX36
Safety and Notes
• Product should be installed and serviced in accordance with
applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power
source and circuit breakers are switched off before performing
any installation or wiring procedures.
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Rev Date: V3 09/10/2020
4400 Earth City Expy, St. Louis, MO 63045
User Manual
DS-DMX36
866-590-3533 superbrightleds.com